S&W Instructions

Shield 9mm +2/40+1 Instructions

1. Fully disassemble the factory magazine.
   Note: depress button on floor plate to remove.
2. Re-insert the factory spring and follower and compress deep
   into the bottom of the magazine.
3. Slide the provided allen wrench into the #8 hole and through the
   magazine to “trap” the spring.
4. Slide the HYVE extension fully onto the magazine.
5. Remove the allen wrench allowing the spring to expand fully.
6. Use the provided set screw to attach the magazine stop to the
   extension.

Shield 9mm+1/40 +1 Instructions

1. Fully disassemble factory magazine.
   Note: depress button on floor plate to remove.
2. Re-insert factory spring and follower and compress deep into
   the bottom of the magazine.
3. Slide the provided allen wrench into the #8 hole and through the
   magazine to trap the spring.
4. Slide the HYVE extension fully onto the magazine.
5. Remove the allen wrench allowing the spring to expand fully.
6. Tighten the provided set screw to secure the magazine in place.

Shield 45+1 Instructions

1. Fully disassemble factory magazine.
2. Re-insert factory spring and follower, compressing the spring
   deep into the magazine.
3. Slide an allen wrench into the “+1” hole and through the
   magazine to “trap” the spring.
4. Slide the HYVE extension fully onto the magazine.
5. Remove the allen wrench allowing the spring to expand fully.
6. Tighten the provided set screw to secure the magazine in place.

M&P 9c/40c Plus 2/3 Instructions

1. Fully disassemble factory magazine.
   Note: Depress button on floor plate to remove.
2. Re-insert factory spring and follower and compress deep into
   the bottom of the magazine.
3. Slide the provided Allen wrench into the #12 hole and through
   the magazine to “trap” the spring and place the floor plate into
   the extension.
4. Slide the HYVE extension fully onto the magazine.
5. Remove the Allen wrench allowing the spring to expand fully.
6. Tighten the provided set screw to secure the magazine in place.

M&P 9/40 Plus 4/5 Instructions

1. Fully disassemble factory magazine.
   Note: depress button on floor plate to remove.
2. Re-insert factory follower and provided spring and compress
   deep into the bottom of the magazine.
3. Slide the provided bigger allen wrench into the #16 hole and
   through the magazine to “trap” the spring.
4. Slide the HYVE extension fully onto the magazine.
5. Remove the allen wrench allowing the spring to expand fully.
6. Tighten the provided set screw to secure the magazine in place.

All M&P Triggers

 Youtube Video